DELL UltraSharp 2405FPW 24" LCD Monitor

Price: Not Available.

Status: Phased Out

Product Description:
24" Widescreen LCD Monitor

Monitor Specifications

General

Model number

2405FPW

Flat Panel

Screen type

Active matrix - TFT LCD

Screen dimensions

24 inches (24-inch diagonal viewable image size)

Preset display area:

Horizontal

518.4 mm (20.4 inches)

Vertical

324.0 mm (12.7 inches)

Pixel pitch

0.270 mm

Viewing angle

+/- 89° (vertical) typ, +/- 89° (horizontal) typ

Luminance output

500 cd/m ²(typ)

Contrast ratio

1000:1 (typ)

Faceplate coating

Antiglare with hard-coating 3H

Backlight

6 CCFLs U-type backlight

Response Time

12ms typical (Grey to Grey) / 16ms typical (Black to White)

Resolution

Horizontal scan range

30 kHz to 81 kHz (automatic)

Vertical scan range

56 Hz to 76 Hz, exception 1680 x 1200 & 1920 x 1200 at 60 Hz only

Optimal preset resolution

Analog : 1920 x 1200 at 60 Hz(VESA CVT-R Mode)
Digital : 1920 x 1200 at 60 Hz(VESA CVT-R Mode)

Highest preset resolution

Analog : 1920 x 1200 at 60 Hz(VESA CVT-R Mode)
Digital : 1920 x 1200 at 60 Hz(VESA CVT-R Mode)

Dell guarantees image size and centering for all preset modes listed in the following table.

Preset Display Modes

Display Mode	Horizontal Frequency (kHz)	Vertical Frequency (Hz)	Pixel Clock (MHz)	Sync Polarity (Horizontal/Vertical)
VGA, 720 x 400	31.5	70.1	28.3	-/+
VGA, 640 x 480	31.5	59.9	25.2	-/-
VESA, 640 x 480	37.5	75.0	31.5	-/-
VESA, 800 x 600	37.9	60.3	40.0	+/+
VESA, 800 x 600	46.9	75.0	49.5	+/+
VESA, 1024 x 768	48.4	60.0	65.0	-/-
VESA, 1024 x 768	60.0	75.0	78.8	+/+
VESA, 1152 x 864	67.5	75.0	108.0	+/+
VESA, 1280 x 1024	64.0	60.0	108.0	+/+
VESA, 1280 x 1024	80.0	75.0	135.0	+/+
VESA, 1600 x 1200	75.0	60.0	162.0	+/+
VESA, 1920 x 1200	74.0	60.0	154.0	+/-

Electrical

Video input signals

Analog RGB: 0.7 Volts +/-5%, 75 ohm input impedance

Digital DVI-D TMDS: 600mV for each differential line, 50 ohm input impedance

S-video: Y input 1 volt(p-p), C input 0.286 volt(p-p), 75 ohm input impedance

Composite: 1 volt(p-p), 75 ohm input impedance,
Component: Y, Pb, Pr are all 0.5~1volt(p-p), 75 ohm input impedance

Synchronization input signals

separate horizontal and vertical,
3.3V Cmos or 5V TTL level, positive or negative sync.
SOG (Sync on green)

AC input voltage / frequency / current

100 to 240 VAC / 50 or 60 Hz + 3 Hz / 2.0A (Max.)

Inrush current

120V: 40A (Max.)
240V: 80A (Max.)

Physical Characteristics

Signal cable type

D-sub: Detachable, Analog, 15pin, shipped attached to the monitor
DVI-D: Detachable, Digital, 24pin, shipped detached from the monitor
S-video: Not included with display
Composite: Not included with display
Component: Not included with display

Dimensions (with stand):

Height (fully extended in portrait mode)

642.7 mm (25.3 inches)

Height (compressed/locked in landscape mode)

546.8 mm (21.5 inches)

Width

559.4 mm (22.0 inches)

Depth

229.0 mm (9.0 inches)

Weight

Monitor (Stand and Head)

10.0 kg (22.1 lb)

Monitor Flat panel only (VESA Mode)

7.0 kg (15.4 lb)

Weight with packaging

13.2 kg (29.1 lb)

Environmental

Temperature:

Operating

5° to 35°C (41° to 95°F)

Nonoperating

Storage: 0° to 60°C (32° to 140°F)
Shipping: -20° to 60°C(-4° to 140°F)

Humidity:

Operating

10% to 80% (noncondensing)

Nonoperating

Storage: 5% to 90% (noncondensing)
Shipping: 5% to 90%(noncondensing)

Altitude:

Operating

3,657.6 m (12,000 ft) max

Nonoperating

12,192 m (40,000 ft) max

Thermal dissipation

272.8 BTU/hour (maximum)
201.2 BTU/hour (typical)

Power Management Modes

If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. This is referred to as 'Power Save Mode'*. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will automatically "wake up". The following table shows the power consumption and signaling of this automatic power saving feature:

VESA Modes	Horizontal Sync	Vertical Sync	Video	Power Indicator	Power Consumption
Normal operation	Active	Active	Active	Green	80 W (maximum)* 59 W (normal)**
Active-off mode	Inactive	Inactive	Blanked	Amber	Less than 2 W
Switch off	-	-	-	Off	Less than 1 W

* With Audio + USB
** Without Audio + USB

NOTE: The OSD will only function in the 'normal operation' mode. Otherwise one of the following messages will appear depending upon the selected input.

1: D-SUB

In Power Save Mode

Press computer power button

or any key on keyboard or move mouse

2: DVI-D

In Power Save Mode

Press computer power button

or any key on keyboard or move mouse

Activate the computer and wake up the monitor to gain access to the OSD.

Pin Assignments

VGA Connector

Pin Number	15-pin Side of the Connected Signal Cable
1	Video-Red
2	Video-Green
3	Video-Blue
4	GND
5	Self-test
6	GND-R
7	GND-G
8	GND-B
9	Computer 5V/3.3V
10	GND-sync
11	GND
12	DDC data
13	H-sync
14	V-sync
15	DDC clock

DVI Connector

Pin Number	24-pin Side of the Connected Signal Cable
1	TMDS RX2-
2	TMDS RX2+
3	TMDS Ground
4	Floating
5	Floating
6	DDC Clock
7	DDC Data
8	Floating
9	TMDS RX1-
10	TMDS RX1+
11	TMDS Ground
12	Floating
13	Floating
14	+5V / +3.3V power
15	Self test
16	Hot Plug Detect
17	TMDS RX0-
18	TMDS RX0+
19	TMDS Ground
20	Floating
21	Floating
22	TMDS Ground
23	TMDS Clock+
24	TMDS Clock-

S-video Connector

Pin Number	5-pin Side of the Connected Signal Cable (Cable not included)
1	GND
2	GND
3	LUMA
4	CHROMA
5	GND

Composite Video Connector

Pin Number	1-pin Side of the Connected Signal Cable (cable not included)
1	LUMA COMPOSITE CHROMA

Component Video Connector

Pin Number	3-pin Side of the Connected Signal Cable (Cable not included)
1	Y (Luminance signal)
2	Pb (Color differential signal)
3	Pr (Color differential signal)

Universal Serial Bus (USB) Interface

This monitor supports High-Speed Certified USB 2.0 interface.

	Data Rate	Power Consumption
High speed	480 Mbps	2.5W (Max., each port)
Full speed	12 Mbps	2.5W (Max., each port)
Low speed	1.5 Mbps	2.5W (Max., each port)

USB Upstream Connector

Pin Number	4-pin Side of the connector
1	DMU
2	VCC
3	DPU
4	GND

USB Downstream Connector

Pin Number	4-Pin Side of the Signal Cable
1	VCC
2	DMD
3	DPD
4	GND

USB Ports

1 upstream - rear
4 downstream - 2 on rear; 2 on right side

NOTE: USB 2.0 capability requires 2.0-capable computer

NOTE: The monitor's USB interface works only when the monitor is on or in power save mode, If you switch the monitor off and then on,
attached peripherals may take a few seconds to resume normal functionality.

Card Reader Specifications

Overview

The Flash Memory Card Reader is a USB storage device that allows users to read and write information from and into the memory card.
The Flash Memory Card Reader is automatically recognized by Windows® 2000 and XP.
Once installed and recognized, each separate memory card (slot) appears as a separate drive/drive letter.
All standard file operations (copy, delete, drag-and-drop, etc.) can be performed with this drive.

Features

The Flash Memory Card Reader has the following features:

Supports Windows 2000 and XP operating systems
No Windows 9X support from Dell
Mass Storage Class device (No drivers are required under Windows 2000 and XP)
USB-IF certification
Supports various memory card media

Slot Number	Flash memory cards type
1	CompactFlash type I/II Card (CF I/II)/ MicroDrive (MD)
2	SmartMedia Card (SMC)
3	Memory Stick Card (MS) ./ Memory Stick Pro Card (MS PRO) / Memory Stick Duo (with Adapter)
4	Secure Digital Card (SD)/ MultiMediaCard (MMC)/ Mini Secure Digital (with Adapter)

General

Connection type	USB 2.0 High Speed Device (USB Full Speed Device compatible)
Supported OS	Windows 2000 and XP

Performance

Transfer Speed	Read: 480 Mb/s (max.)
	Write: 480 Mb/s (max.)

DellSound Bar (Optional) Specifications

System Frequency Response	95 Hz to 20 kHz @ 10 dB below avg. SPL
Total Power Output	14 W continuous average power (all speakers operating) @ 10% (THD+N), 1 kHz (FTC rated)
Headphone Jack Output Power	40 mW continuous average power (RL = 32Ω) @ 10% (THD+N), 1 kHz
Input Sensitivity for Rated Output	500 ± 50 mVrms @ 1 kHz
Input Impedance	>10kΩ
Maximum Input Signal Voltage	2 Vrms
Controls	Power On/Off Volume Control
Input Cables	3.0 m ± 0.1 m AWG26 black cable attached to enclosure, with 3.5 mm lime green stereo plug
Power Requirements	DC12V, 1.5A +/-10%
Power Cord Length	305 mm ± 15 mm AWG22 black cable attached to enclosure, with DC plug (5.5 x 2.1 x 12 mm)
Operating Temperature Range	10°C to 40°C
Humidity, Non-condensing	95% RH @ 40 °C

Plug and Play Capability

You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. If desired, the user can select different settings, but in most cases monitor installation is automatic.

Located in the Philippines!

DELL UltraSharp 2405FPW 24" LCD Monitor

Brands In Category

General

Physical Characteristics

VGA Connector

DVI Connector

S-video Connector

Composite Video Connector

USB Upstream Connector

USB Downstream Connector

USB Ports